Switching Off; Changing The Battery - LIVARNO LUX IAN 280090 Instrucciones De Utilización Y De Seguridad

between the basic colours red, green and
blue (RGB).
STROBE: Press the STROBE button
select a sophisticated colour change program:
- white light flashes 6 times, then ...
- RGB light colours alternate with a „rough"
transition, then ...
- 7-colour change with a „rough" transition,
then ...
- RGB light colours change with a „soft"
transition, then ...
- 7-colour change with a „soft" transition.
FADE: Press the FADE button
ate a colour change between 7 colours and
a „soft" transition.
SMOOTH: Press the SMOOTH button
to generate a colour change between
7 colours and a „rough" transition.
Repeatedly press the
ually increase the speed of the respective
colour change.
Repeatedly press the
ually reduce the speed of the respective col-
our change.
There are 5 speeds to choose from.
Activating the respective colour change
automatically selects the lowest speed.
32 GB/MT
to
9
to gener-
10
11
button to grad-
3
button to grad-
4

Switching off

When switching the lamp
OFF button on the remote control
5
when switching the light back on using the
ON button the last colour or the last
6
colour change selected will be used.
However, when disconnecting the power
supply to the light by switching the light off,
when switching the light
light will always light up white with medium
light intensity.

Changing the battery

Change the battery
16
the remote control
2
or the light no longer responds to the
1
remote control being operated.
To do so, proceed as shown in Figure B.
Only use a battery type CR2025 and note
the correct polarity when inserting the
battery. This is shown on the back of the
remote control.
off using the
1
,
2
back on the
1
when the range of
noticeably decreases