Publicidad
SERVICE AND ADJUSTMENT
HOW TO REPLACE
THE MOTION DRIVE BELTS
ENGINE
DRIVE
BELT REMOVAL
1.
Remove the mower housing. See the instructions on "How To
Remove The Mower Housing".
2.
Set the rear hitch on a 10 to 12 inch block. The block must be
high enough to raise the rear whee! of off the ground (see
Figure 31).
3.
Remove
the rear wheels.
4.
Remove the idler pulley (see Figure 32).
5.
Remove the bolt from the torque strap (see Figure 33).
6.
Loosen the nuts from each side of the transmission
(see
Figure 34). Do not remove the nuts. Loosen until the nuts are
at the top of the bolts.
7.
Slip the rear of the motion drive belt over the drive pulley and
out the front of the transmission. Then, pull the motion drive
belt down between the belt guides and the stack pulley (see
Figure 35).
8.
To install, reverse the above steps.
9.
Install
the mower
housing.
See the instructions
on "How
To
Install The Mower
Housing".
10.
Check the operation
of the drive system.
See "How To Check
And Adjust
The Clutch"
and also "How
To Adjust
The Speed
Control
Lever".
Figure 31
Stack Pulley
Figure 32
Figure 33
Figure 34
Belt
iiiiiiiiiiiiiiiiiiiii
Guide iiiiiiiiiiiiiiiiiiiii
F-050607L
31
Publicidad
