Akron STYLE 3000 AEROMASTER 12 Instrucciones De Instalación, Funcionamiento Y Mantenimiento página 14

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Any.of.the.following.functions.may.be.configured.by.stopping.at.that.function.and.performing.the.operation . . See.the.appropriate.
section.for.detailed.information.on.configuration.of.each.function .
Setup Menu Function
Setup.Mode.Start
Right.Soft.Limit.Position
Left.Soft.Limit.Position
Up.Soft.Limit.Position
Down.Soft.Limit.Position
Monitor.Orientation
Position.Sensor."Zero"
Restore.Factory.Defaults
Obstacle.Avoidance.Disable
Obstacle.Avoidance.Manual.Operation
Obstacle.Avoidance.Auto.Operation
Obstacle.Avoidance.Learn
Stow.Position
Deploy.Position
Setup Mode Table for LED Codes
While.any.and.all.of.these.configurations.are.optional,.if.a.monitor.orientation.is.mounted.sideways.or.inverted,.the.monitor.
orientation.will.need.to.be.configured.for.proper.operation . . If.at.any.point.it.is.determined.that.an.undesirable.mode.is.active,.it.
is.possible.to.abort.the.mode.by.removing.power.to.the.Aeromaster.12.prior.to.activating.the.Fog.input . . If.it.is.determined.that.an.
undesired.function.may.have.been.saved,.it.may.be.desirable.to.use.the."Restore.Factory.Defaults".function.(LED.Code.1-9) . . When.all.
desired.changes.have.been.made,.cycling.power.will.return.the.monitor.to.normal.operation.and.the.changes.that.were.made.will.be.
in.effect . . The.changes.can.also.be.saved.by.pressing.the.Fog.switch.when.in.setup.start.mode.(one.single.blink) .
+The.position.sensors.are."zeroed".at.the.factory . . The.default.zero.position.is.facing.straight.ahead.with.the.nozzle.level.(0º.
elevation) . . If.the.monitor.is.physically.mounted.such.that.this.is.not.the.zero.position.for.your.installation,.you.will.need.to.re-zero.
the.monitor.before.it.can.be.used.with.a.6036.Direction.Indicator .
++NOTE: Use of this function will clear all stored obstacle avoidance option profile data and require the obstacle avoidance to
be re-programmed..Factory.defaults.are.set.to.a.soft.limit.location.beyond.the.hard.stops.so.that.the.monitor.will.have.full.range.of.
motion.between.hard.stops.until.the.soft.limits.are.reset .
LED Code
1.slow.blink
1-1
1-2
1-3
1-4
1-7
1-8+
1-9++
2-1
2-2
2-3
2-4
1-5
1-6
Page.12

Publicidad

Tabla de contenido
loading

Tabla de contenido