ClearSounds CS-A300 DECT 6.0 Manual Del Usuario página 33

Interference Information: Part 15 of FCC Rules
Some telephone equipment generates, uses, and can radiate radio-frequency
energy and, if not installed and used properly, may cause interference to radio
and television reception. Your product has been tested and found to meet
the standards for a Class B digital device, as specified in part 15 of the FCC
Rules. These specifications are designed to provide reasonable protection
against such interference in a residential installation. However, there is
no guarantee that interference will not occur in a particular installation.
If your product causes interference to radio or television reception when
it is in use, you might correct the interference with any one or all of these
measures: (a) where it can be done safely, reorient the receiving television
or radio antenna. (b) To the extent possible, relocate the television, radio
or other receiver with respect to the telephone equipment. (c) If your
telephone product runs on AC power, plug your product into an AC outlet
that is not on the same circuit as the one used by your radio or television
INDUSTRY CANADA CS03 STATEMENT
This product meets the applicable Industry Canada technical
specifications. This is confirmed by the registration number. The
abbreviation, IC before the registration number signifies that
registration was performed based on a Declaration of Conformity
indicating that Industry Canada technical specifications were met. It
does not imply that Industry Canada approved the equipment.
Before installing this equipment, users should ensure that
it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed
using an acceptable method of connections. The customer should be
aware that compliance with the above conditions may not prevent
degradation of service in some situations.
Repairs to certified equipment should be made by an authorized
Canadian maintenance facility designated by the supplier. Any repairs
or alterations made by the user of this equipment, or equipment
malfunctions, may give the telecommunications company cause to
request the user to disconnect the equipment.
WARNING! Users should not attempt to make such connections
themselves, but should contact the appropriate electric inspection
authority, or an electrician, as appropriate.
CAUTION: The Ringer Equivalence Number (REN) assigned to each
terminal device provides an indication of the maximum number of
terminals allowed to be connected to a telephone interface.
The termination on an interface may consist of any combination
of devices subject only to the requirement that the sum of the
33 – ENGLISH