Using Your Ceiling Fan - Fanaway LED EVO1 Manual De Instrucciones

Fanaway LED EVO1 Installation Instructions

Connect the female plug (fan motor) and male plug (mounting bracket) together
(1 – Fig.12).

Slide the canopy (No.3– Fig. 1) onto the mounting bracket using the slotted holes.
Align the other 2 holes and then install the 2 other screws. Tighten all four screws
firmly. Avoid damaging the electrical wiring prepared previously.
FAN WALL CONTROL
Turn on the power and check the operation of the fan.
• OFF Position – fan off
• 3rd Position – low fan speed
• 2nd Position – medium fan speed
• 1st Position – high fan speed
Light Control
• Toggle switch – on/off
Using LED fitting with dimmer (not included)
WARNING:

FOR YOUR SAFETY ALL ELECTRICAL CONNECTIONS MUST BE UNDERTAKEN BY A LICENSED
ELECTRICIAN.

AN ISOLATION SWITCH MUST BE INSTALLED BEFORE DIMMER IN THE FIXED WIRING.

DO NOT use a remote control which has a dimming function to control this LED fitting.
This LED light kit is dimmable and has been tested with Clipsal 32E450TM, 32E450UDM and LUCCI SKU# 290998
dimmers only. The use of non-recommended dimmers will void warranty and may damage your LED light fitting.
NOTE: For use with LUCCI SKU# 290998 trailing edge dimmer, the best dimming performance is achieved by
adjusting the variable resistor at the minimum and maximum dimming position on this dimmer during the install.
NOTE: Dimming may cause buzzing sounds or a slight flicker. Slight delays with the lamp starting up and slight
uneven light performance can occur when more than one LED light fitting is linked together, switched ON and dimmed.
9 | P a g e
FINISH THE INSTALLATION

USING YOUR CEILING FAN

Fig. 13
Fig. 12
V e r 1 . 0