Technical Data; Power Requirements - Truper CEP-12 Manual De Instrucciones

Technical data

Code
Description
Measurements
Voltage
Frequency
Current
Power
Speed
Work Cycle
Conductors
Insulation
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
WARNING Before gaining access to the terminals all power sources should be disconnected.

Power Requirements

WARNING The tool shall be grounded while in use to prevent an
electric shock. • Connect the plug into a properly grounded outlet as shown in
example A. Not all the outlets are properly grounded. If in doubt verify with a
certified electrician. • If the outlet you plan to be using for the tool has two
poles (2 orifices). FOR NO REASON AT ALL DO NOT REMOVE OR ALTER
THE GROUND CONDUCTOR IN THE PLUG. Use a temporary adaptor as
shown in example B and always connect the ground lug as indicated.
CAUTION When using an extension cable, verify the gauge is enough
for the power that the tool needs. A lower gauge cable will cause voltage drop in the line, resulting in power loss and the motor will
overheat. The following table shows the right size to use depending on cable's length and the ampere capability shown in the tool's
nameplate. When in doubt use the next higher gauge.
Ampere
Capacity
From 0 and up to 10 A
From 10 and up to 13 A
From 13 and up to 15 A
From 15 and up to 20 A
* It is safe to use only if the extensions themselves have an artifact for over current protection. AWG = American Wire Gauge. Reference: NMX-J-195-ANCE
WARNING
When operating power tools outdoors use a grounded extension cable labeled "Outdoor Use"
brand. These extension cables are specially designed to be used outdoors and reduce the risk of an electric shock.
22,8" x 27" x 18,2"
10 000 RPM
120 minutes' work and 30 minutes' rest. Maximum 6 hours daily.
14 AWG x 3C with 221 °F insulation.
Power Cord Grips used in this product: Type "Y".
Tool Build Quality: Basic insulation
Thermal insulation on motor winding: Class B
Number of
Conductors
From 5,9 ft to 49 ft
3 (one grounded)
CEP-12
16240
Portable Planer
Weight
127 V
60 Hz
15 A
2 1/4 Hp
Cutting Speed
Class I
Authorized Service Center.
CAUTION
Extension Gauge
| Higher than 49 ft
18 AWG
16 AWG
14 AWG
8 AWG
68 lbs
20 000 cuts/min
A
B
16 AWG
14 AWG
12 AWG
6 AWG
3
ENGLISH