Cutting Depth Adjustment - Truper CEP-12 Manual De Instrucciones

Cutting Depth Adjustment

• Thickness in the work piece will depend on the distance
of the cutter head and the work piece.
• To adjust the distance, turn the cutting depth control
hand shank (J).
• The cutting depth adjustment can be read in the depth
scale (K). The grading of the adjustment is 1/16" per hand
shank turn.
• Always start the job making a light planning cut. Cutting
depth in the subsequent steps may be increased up to
1/8". However, remember that a light cut produces a finer
finish than a thick cut.
WARNING • Never carry out planning above 1/8" in
one step. Neither try to work wood smaller than 5" long.
Always wear protective face mask. Do not work on pieces
with a thickness smaller than 3/16". Do not work pieces
with a thickness greater than 6".
Feeding the Work Piece
• Feeding direction is pushing towards the planer front as
indicated in the graph. Do not try to do it from the rear.
• Support the work piece on the table extension using both
hands. Push the piece inside the planner. Do not take it off
the table.
WARNING • Use care. Do not put hands inside the
planer to avoid severe injuries.
• The outward pieces can be set on return rollers to return the
pieces to the operator and facilitate making gradual cuts in the
same piece.
• Consider the following table to get a
CAUTION
quality job and prevent accidents:
Feeding length (minimum):
Feeding width (maximum):
Feeding thickness:
Cutting depth (maximum):
Feeding speed:
*(feet per minute)
10
ENGLISH
5''
12-1/2''
0,2'' - 6''
1/8''
26,2 fpm*
Start Up
J
K