Troubleshooting - Truper CEP-12 Manual De Instrucciones

Problem
Hairy finish.
Torn fibers.
Rough or raised fibers.
Poor wood feed.
Stuck work piece.
Uneven cutting depth
from side to side.
The piece thickness in
not matching the scale
reading.
The chain jumps.
The machine does not
start.
The motor stops
repeatedly.
12
ENGLISH
Cause
• Wood has too much humidity.
• Dull blades.
• Cut is too thick.
• Blades cutting against the
fibers.
• Dull blades.
• Dull blades.
• The cut is too thick.
• High contents of humidity.
• Damaged cutter head
bearings.
• The planer table is dirty.
• Damaged feed rollers.
• Damaged sprocket.
• Damaged bearing box.
• Incorrect blade height
adjustment.
• Misaligned blade.
• The cutter head is misaligned
to the table.
• The cutting scale guide in not
adjusted.
• Misaligned sprockets.
• Worn sprockets.
• It is unplugged.
• The protection switch fuse is
broken.
• Motor failure.
• Loose connections.
• Protection switch restarting.
• The power extension is too
long or the gauge is low.
• Dull blades.
• Working with low voltage.

Troubleshooting

Solution
• Dry the wood.
• Sharpen the blades.
• Check the right cutting depth.
• Feed the wood piece in the fibers direction or turn around the
piece 180°.
• Sharpen the blades.
• Sharpen the blades.
• Check the right cutting depth.
• Dry the wood.
• Go to a
replace the bearings.
• Remove dirt or residues. Lubricate table.
• Go to a
• Go to a
• Go to a
• Adjust the blade to the right height.
• Adjust the blade.
• Adjust the cutter head and the table.
• Adjust the cutting depth scale.
• Align sprockets.
• Go to a
• Connect the plug.
• Go to a
• Go to a
• Go to a
• Allow the machine to cool down before starting again.
• Use a shorter power extension or with a higher gauge.
• Sharpen or replace the blades.
• Verify the feeding voltage.
Authorized Service Center to
Authorized Service Center.
Authorized Service Center.
Authorized Service Center.
Authorized Service Center
Authorized Service Center.
Authorized Service Center.
Authorized Service Center.