When you add grease, always use the procedures given in
to motors, also use the procedures given in
CAUTION
21 : Risk of damage—Bad lubricant will decrease the life of components.
• Make sure that all equipment and fittings used to apply lubricants are clean.
• Use only the given lubricants or equivalent lubricants that have the same specifications.
Table 9: Lubricant Identification
Code
Type
EM
grease
EPLF2 grease
Grease Gun Procedures
3.1.4.1.
CAUTION
22 : Risk of damage—Hydraulic pressure can push out seals and push grease
into unwanted areas (example: motor windings).
• Use a hand grease gun. A power grease gun gives too much pressure.
• Know the quantity of grease your grease gun gives each cycle (each stroke).
• Operate the grease gun slowly (10 to 12 seconds for one cycle).
• Add only the specified quantity. Stop if new grease come out of a drain port or other
opening.
• Remove spilled grease from belts and pulleys.
The tables give grease quantities in fluid ounces (fl oz) and milliliters (mL). You can also use
grease gun cycles (strokes). A cycle is each time that you pull the trigger. One cycle is usually
approximately 0.06 fl oz (1.8 mL). Your grease gun can give more or less than this. Measure the
output of your grease gun as follows:
1. Make sure that the grease gun operates correctly.
2. Operate the grease gun to put grease into a small container with fluid ounce or milliliter
increments. Pull the trigger fully and slowly.
3. Add a sufficient quantity of grease to measure accurately. Count the number of cycles of the
grease gun (the number of times that you pull the trigger).
4. Calculate the quantity for each cycle of the grease gun.
Example: 2 fl oz / 64 cycles = 0.031 fl oz for each cycle
Example: 59 mL / 64 cycles = 0.92 mL for each cycle
Procedures for Bearing Components Connected to a Grease Plate
3.1.4.2.
machine has a grease plate on the machine housing or the shell. You add grease to components of
the bearing housing at this location. The correct procedure is to add grease when the cylinder
turns at wash speed, but obey these precautions:
• For all other grease maintenance, add grease with power removed from the machine.
• If the grease plate on your machine is not serviceable (if you must add grease at a different
location), add grease with power removed from the machine.
• If you must remove a guard to get access to the grease plate, prevent access to the machine by
other personnel.
Section
Trademark Name
Mobil Polyrex EM or as given on
the motor nameplate
Shell Alvania EP (LF) Type 2
25
Chapter 3. Routine Maintenance
Section
3.1.4.1. When you add grease
3.1.4.3.
Application Example
motor bearings
drive shaft bearings and bushings,
ball joints
PELLERIN MILNOR CORPORATION
—Your