Operation Of Equipment - GNATUS Optilight Max Manual Delpropietario

operation oF equipment

Hand piece
CORRECT
positioning for
battery charging.
• Press the button (05) to turn on the equipment.
• Select the application mode pressing the selection button (09), of which the variations are:
- Continuous: Maximum and continuous mode of light intensity (same luminosity from
start to finish of
the polymerization).
- Ramp: Gradual mode of light intensity; it increases gradually.
- Pulsed: Pulsing mode consisting of cycles which oscillate at a fixed frequency.
The application mode chosen will be viewed in the sequence of LEDs (15).
• In order to schedule the time press the button (08) and choose the time 5 thru 20
seconds, which will be viewed in the display (07).
• After selecting the mode of application and the choice of time, take the handpiece to
the patient's mouth and position the light guide at a safe distance.
• In order to start the polymerization cycle, press the start button (05). To interrupt it
Just activate it again.
39
15
07
08
09
05
Hand piece
14 INCORRECT
positioning for
battery charging.