GNATUS Optilight Max Manual Delpropietario página 40

operation oF equipment
ATTENTION:
- Recharge the battery when one of the LED continuous, ramp and pulsed are
blinking;
- Keep the handpiece in the charging base (connected to the mains power)
when not using;
- When the LED of the charging base (14) is indicating red, the battery is being
charged;
- The approximate recharging time is 3 hours. After recharging the LED in the charging
base (14) it will change to green, indicating the complete recharging;
- The battery does not have a memory effect and can be recharged even if it is not
completely discharged.
application types: continuous, ramp and pulsed
* Tolerance is ± 200 mW/cm²
40
• Continuous:
Maximum and continuous mode of light
intensity (same luminosity from start to
finish of the polymerization).
• Maximum power = 1200 mW/cm²*
• Ramp:
Gradual mode of light intensity, it
increases gradually.
• Gradual increase = 500 - 1200 mW/cm²*
• Pulsed:
Pulsing mode consisting of cycles which
oscillate at a fixed frequency.
• On/off every 1sec. maximum power =
1200 mW/cm²*