Attaching The Internal Filter Into The - Fulgor Milano F6FBM36S1 Instrucciones Para El Uso

Installation
3.11 Attaching the internal filter
into the refrigerator
1. Pull the water filter cover slowly.
2. Remove the water filter bypass cover by turning
it downwards.
A
WARNING:
is enabled before removing the by-pass
cover.
C
It is normal that a few drops of water drip
after the cover has been removed.
3. Seat the water filter cover into the mechanism
and push forwards to lock it in place.
4. Press "Ice Off" button on the display again to
exit this mode.
C
Water filter must be replaced every 6
months. When replacing the water filter
or if you will not use the filter anymore,
remove it as illustrated in the figure and
install the bypass cover. Make sure that the
"Ice Off" mode is enabled before removing
the filter.
Ensure that the Ice Off mode
A
WARNING:
foreign particles in the water. It does not
purify water from microorganisms.
A
WARNING: Ice Off
pressed before replacing the water filter or
installing the by-pass cover.
A
WARNING:
replacement of the filter.
3.12 Before starting to use the
water/ice dispenser
Water system of the refrigerator must be
connected to the cold water line. It must not
be connected to hot water line.
No water may be obtained in the initial start-
up of the refrigerator. Because there is air in
the system. To discharge air from the system,
press dispenser latch for 1-2 minutes until
water comes from the dispenser. Water flow
may be irregular at the beginning. After the
air in the system is discharged, water flow will
return to normal.
During initial use, you will have to wait
approximately 12 hours for the water to cool
down.
It will take around 1-2 days for the system to
produce required amount of ice.
The first 10 glasses of water should not be
consumed.
First several glasses of water may be turbid
when the filter is used for the first time.
Therefore, do not consume the first several
glasses of water.
If the water dispenser is not used for a long
period of time, first 1-2 glasses of water can
be hot.
If a power outage or a temporary failure occurs
while the refrigerator is operating, ice can melt
down a little bit and then get frozen again. In
such a case, ice cubes can stick to each other.
If the outage or failure prolongs, ice can melt
down causing water leakage. If you experience
such a problem, empty and clean the ice
container.
13 / 33 EN
Water filter cleans some
button must be
Unplug the product during the
Refrigerator / User Manual