Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
www.trapp.com.br
Fixed hammers
Hammers (1) are provided with 2 dented corners
which position can be changed as they wear out.
To change their position, remove the fixing screws
(2) as in the Figure 17.
1
Figure 17
TRF 700F
To change motor oil
Establish the temperature range foreseen before
next change of oil. All oils must correspond to API
SG-SL classification.
1. Equipment must be on a flat and level surface.
2. Hot oil will drain better.
3. Collect used oil in proper container.
4. Carefully unscrew oil container (1) to prevent
accidents such as burns.
1
Image merely illustrative
Techtening of the screws
Due to impact and constant vibrations caused
by chopping and grinding of materials, it is a
natural tendency for screws to loosen.
Check them periodically, and if necessary
tighten the screws.
2
Always turn off shredder and unplug it
before servicing or cleaning.
Belts
It is recommended to weekly check the conditions
of use and tensioning of all the belts of the shredder
(driven by motor or tractor attachments).
Image
merely illustrative
Oil Change
If motor is hot when changing oil, be
careful to remove oil container. Hot oil
is released with more pressure, and may
cause burns.
1. When oil has been fully drained, screw back oil
2. Remove the crankcase oil inlet cover (2) and
Attention!
Attention!
2
container.
insert 20W50 oil according to the motor model.
a. 13.5 HP motor (Briggs & Stratton): 1.15 liters.
b. 15 HP motor (TRAPP / Lifan): 1.1 liters.
3
61
Publicidad
Tabla de contenido
