Multi Link™ Expansion Port - Installation And Use (Optional); Light Attenuation Control; Lamp Life Indicator - Welch Allyn CL 100 Surgical Illuminator Manual De Mantenimiento Del Operador

8
3. Insert, until fully engaged (snap sound), the Light Source end into the Multi Link™
Port.
4. Turn on Light Source. Adjust the light attenuator to the required illumination level.
Multi Link™ Expansion Port - Installation and Use (optional)
Note
To use the Multi Link™ Expansion Port perform the following operations:
1. Close the light attenuator or turn the Light Source off.
2. Remove, if any, Micro Link
3. Insert the Multi Link™ Expansion Port, press and turn clockwise until it locks into
place.
4. Connect the fiber bundle to the instrument.
5. Insert, until fully engaged, the Light Source end of the fiber bundle into the Multi
Link™ Expansion Port.
6. Turn on Light Source. Adjust the light attenuator to the required illumination level.
To remove the Multi Link™ Expansion Port perform the following operations:
1. Turn the Light Source off.
2. Remove the fiber bundle.
3. Turn Multi Link™ Expansion Port counter-clockwise until unlocked and remove.

Light Attenuation Control

Moving the illumination wheel up
reduces light output.

Lamp Life Indicator

Caution The Multi Link™ Expansion Port contains optical elements that can
become damaged if dropped or abused.
The Multi Link™ Expansion Port must be fully engaged into the Light Source
before inserting Fiber Bundle.
®
Caution A yellow indicator light located on the console will light when there is
approximately 50 hours remaining on the lamp. A new CL Series Replacement
Lamp should be available at this point. Once the remaining hours have been
exhausted the lamp will turn off.
Fiber or fiber bundle from the Multi Link™ Port.
+
increases light output. Moving the wheel down
CL100 / CL300 Surgical Illuminator
—