LG LRE3021ST Manual Del Propietário página 35

Problem
Oven light does not work.
Oven smokes excessively dur-
ing broiling.
Food does not bake or roast
properly.
Food does not broil properly. y Improper rack position being used. Refer to the "Removing and replacing oven racks"
Food does not broil properly. y Aluminum foil used on the broiling pan and grid has not been fitted properly and slit as
Displayed Time is flashing.
Oven control display PF mes-
sage.
Oven temperature too hot or
too cold.
Scratches or abrasions on
cooktop surface.
y Replace or tighten bulb. See the "Oven light" section.
y Control not set properly. Refer to the "Using the oven" section.
y Meat is too close to the broil element. Reposition the rack to provide proper clearance
between the meat and the element.
y Meat is not properly prepared. Remove excess fat from meat. Cut remaining fatty edges to
prevent curling.
y Broiler pan is upside down and the grease is not draining. Always place the grid on the
broiler pan with ribs up and slots down to allow grease to drip into the pan.
y Grease has built up on oven surfaces. Regular cleaning is necessary when broiling fre-
quently.
y Old grease or food spatters cause excessive smoking. Clean the interior of the oven.
y Oven controls improperly set. See the "Using the oven" section.
y Rack position is incorrect or the rack is not level. Refer to the "Rack and Pan Placement"
section.
y Incorrect cookware or cookware of improper size being used. Refer to the "Using the
proper cookware" section.
section.
y Cookware not suited for broiling.
recommended.
y In some areas the power voltage may be low. Preheat the broil element for 5-7 minutes.
Refer to the Broiling Guide.
y This is normal. This means that the product has just been plugged in, or that it has ex-
perienced a power interruption. To clear the flashing time, press any key and reset the
clock if needed.
y "PF" means there has been a power interruption in your home. Press Clear/off Key and
the "On/Off" key on the cooktop controls to clear this code. It may also require you to
reset the time for the display.
y Oven Sensor needs to be adjusted. Refer to the "Using the oven" section.
y Coarse particles such as salt or sand between cooktop and utensils can cause scratches.
y Be sure cooktop surface and bottoms of utensils are clean before usage. Small scratches
do not affect cooking and will become less visible with time.
y Cleaning materials not recommended for ceramic-glass cooktop have been used. Refer
to the "Care and Cleaning" section.
y Cookware with rough bottom has been used. Use smooth, flat-bottomed cookware.
Possible Causes / Solutions
35
tROUbLEShOOtiNg