Black and Decker LST136 Manual De Instrucciones página 13

2_WARNING:
To avoid serious injury, remove the battery from
the tool before performing any maintenance.
1. Keep the air intake slots clean to avoid overheating.
2. Your trimmer line can dry out over time. To keep your line in top
condition, store spare pre-wound spools or bulk line in a plastic,
sealable bag with a tablespoon of water.
3. Plastic parts may be cleaned by using a mild soap and a damp rag.
4. The line cutter on the edge of the guard can dull over time. It is
recommended you periodically touch-up the sharpness of the
blade with a file.
PROBLEM
Toot runs slowly.
Automatic line feed does not
feed more line.
SOLUTION
• Remove battery from tool.
Check that the spool housing
can rotate freely. Carefully clean
it if necessary.
• Check that the cutting line
does not protrude more than
approximately 4-13/16 inches
(122mm) from the spool.
If it does, cut it off so that it just
reaches the line trimmingblade.
• More line is fed when the line
shortens to approximately 3
inches (76.2mm). To determine
if the line is not feeding, let line
wear past this point.
PROBLEM
Automatic line feed does not
feed more line.
13
SOLUTION
• Keep the tabs depressed and
remove the spool from the spool
housing in the trimmer head.
• Ensure that the line is not
crisscrossed on the spool as
detailed infigure U If it is,
unwind the cutting line, then
wind it back on the spool neatly
so that the lines do not cross.
• Inspect tracks at the bottom of
spool for damage. Ifdamaged,
replace spool.
•Read the code on the back of
spool. Ifit reads "PA66" call
customer service for a replacement.
If it reads "ABS" this is not the issue.
• Pullthe cutting line until it
protrudes approximately 4-13/16
inches (122mm) from the spool. If
insufficient cutting line is left on the
spool,installa new spool of cutting
line.
• Align the tabs on the spool cap
with the cut outs in the housing.
• Push1hespool cap onto the housing
until it snaps securely into place.
• Ifthe cutting line protrudes
beyond the trimming blade, cut
it off so that it just reaches the blade.
If the automatic line feed still does
not vvorkor the spool is jammed, try
the following suggestions:
• Carefully clean the spool and
housing.
• Remove the spool and check if the
lever in the spool housing can
move freely.