Publicidad
Idiomas disponibles
Idiomas disponibles
Read and understand
all instructions.
Failure to follow all instructions
listed below, may result in electric shock, fire and/or serious
personal injury.
SAVE THESE
INSTRUCTIONS
Work Area
Keep your work area clean and well lit.
Cluttered
benches
and dark areas invite
accidents.
Do not operate
power
tools in explosive
atmospheres,
such as in the presence
of
flammable
liquids,
gases,
or dust. Power
tools create sparks which may ignite the
dust or fumes.
Keep by-standers,
children,
and visitors
away while operating
a power tool.
Distractions
can cause you to lose control.
Electrical Safety
Double Insulated tools are equipped with
a polarized
plug (one blade is wider than
the other.)
This plug will fit in a polarized
outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug. If it
still does not fit, contact
a qualified
electrician
to install a polarized outlet.
Do not change the plug in any way.
Double Insulation
[]
eliminates
the need
for the three wire grounded
power cord and
grounded
power supply system.
Before
plugging
in the tool, be certain the outlet
voltage supplied
is within the voltage
marked on the nameplate.
Do not use "AC
only" rated tools with a DC power supply.
Avoid body contact
with grounded
surfaces such as pipes, radiators, ranges
and refrigerators.
There is an increased
risk of electric shock if your body is
grounded.
If operating
the power tool in
damp locations
is unavoidable,
a Ground
Fault Circuit Interrupter
must be used to
supply the power to your tool. Electrician's
rubber gloves and footwear
will further
enhance your personal safety.
Don't expose
power
tools to rain or wet
conditions.
Water entering
a power tool
will increase the risk of electric shock.
Do not abuse the cord.
Never use the
cord to carry the tools or pull the plug
from an outlet.
Keep cord away from
heat, oil, sharp
edges or moving
parts.
Replace
damaged
cords
immediately.
Damaged
cords increase the risk of electric
shock.
When operating
a power
tool outside,
use an outdoor
extension
cord marked
"W-A"
or "W." These cords are rated for
outdoor use and reduce the risk of electric
shock.
Refer to "Recommended
sizes of
Extension Cords" in the Accessory
section
of this manual.
Personal
Safety
Stay alert, watch what you are doing and
use common
sense when operating
a
power tool. Do not use tool while tired or
under the influence
of drugs, alcohol,
or
medication.
A moment
of inattention
while
operating
power tools may result in serious
personal
injury.
Dress
properly.
Do not wear loose
clothing
or jewelry.
Contain
long hair.
Keep your hair, clothing,
and gloves
away from moving
parts.
Loose clothes,
jewelry, or tong hair can be caught in
moving
parts. Keep handles
dry, clean and
free from oil and grease.
Avoid
accidental
starting.
Be sure switch
is "OFF"
before
plugging
in. Carrying
tools with your finger on the switch or
plugging
in tools that have the switch
"ON"
invites accidents.
Remove
adjusting
keys or wrenches
before
turning
the tool "ON".
A wrench
or
a key that is left attached
to a rotating
part
of the tool may result in personal injury.
Do not overreach.
Keep proper
footing
and balance
at all times.
Proper footing
and balance
enables
better control of the
tool in unexpected
situations.
Use safety
equipment.
Always
wear eye
protection.
Dust mask, non-skid
safety
shoes, hard hat, or hearing
protection
must
be used for appropriate
conditions.
Tool
Use
and
Care
Use clamps or other practical
way to
secure and support the workpiece
to a
stable platform.
Holding the work by hand
or against your body is unstable
and may
lead to loss of control.
Do not force
tool. Use the correct
tool for
your application.
The correct
tool will do
the job better and safer at the rate for which
it is designed.
Publicidad
