Installing Your Sliding Glass Pet Door; Measure; Install Sliding Glass Pet Door - Petsafe PPA11-14766 Manual De Instalación

Recessed Sliding Glass Frame: Sliding glass door frame that is flush with or barely visible in
interior or exterior wall
Rise: The height from the floor to the bottom of the flap in the pet door. It is the height the pet
must step over to enter or exit the pet door.
Panel Rib Line: Raised ribbed lines on left and right side of Sliding Glass Pet Door frame to
indicate drilling outside of rib line area. Do not drill inside of the rib line as glass is present and
will break if drilling occurs in this area.
Operating Temperature Range: 0º F to 100º F (-18º C to 38º C)

Installing Your Sliding Glass Pet Door

Prior to installation and drilling, consult your sliding glass door manufacturer's
warranty. Unauthorized changes or modifications may void the warranty.
Installing screws into vinyl door frames or door jambs may crack the vinyl.
Step 1

Measure

1A. Prior to any Sliding Glass Pet Door purchase, you must
determine the height of your sliding glass door frame opening.
Measure from highest point in upper door track to lowest point
in lower door track.
Step 2

Install Sliding Glass Pet Door

2A. Before proceeding with installation, assemble the top and
bottom panels to be one piece. Slide the connecting bars into
into the bottom panel holes and insert (2) 3/8" Flat Head Screws
into each connecting bar. Then slide the top panel down over
the connecting bars and insert 2 screws on each side. Check
alignment of the 2 door panels then tighten all 8 screws.
NOTE: Remove all packaging materials, including cardboard
inserts inside the height adjuster.
Use care when assembling the two halves of
the door together. This could be a potential
pinch point and could lead to injury.
www.petsafe.net
1A
2A
Connection
Bar
Bottom
Door
Section
5