Attach The Sliding Glass Pet Door - Petsafe PPA11-14766 Manual De Instalación

2B. The Sliding Glass Pet Door inserts into the opening
in your sliding glass door against the doorjamb. Your sliding
glass door will close against the Sliding Glass Pet Door.
With sliding glass door open, insert the top of Sliding Glass
Pet Door with height adjuster into upper door track on interior
side of sliding glass door. Lift up and position bottom of Sliding
Glass Pet Door into lower door track on interior side of the
sliding glass door. Ensure the side of the Sliding Glass Pet
Door showing flap screw heads is on the interior side of your
sliding glass door.
NOTE: You may need to pull down the height adjuster to fit
the Sliding Glass Pet Door in your sliding glass door track.
Firmly pull down one side and then the other.`
2C. Move the Sliding Glass Pet Door against the doorjamb.
The Sliding Glass Pet Door should fit flush against
the doorjamb without any gaps. Make sure the height adjuster is
fully extended and not tilted to one side. Ensure you are satisfied
with the fit of the Sliding Glass Pet Door before drilling.
Step 3

Attach the Sliding Glass Pet Door

3A. Slide the Sliding Glass Pet Door out slightly from door jamb
to show pre-drilled holes in height adjuster. Drill
holes through the two pre-drilled holes on interior side of height
adjuster. Secure height adjuster to Sliding Glass Pet Door using
two / " sheet metal screws. Slide Sliding Glass Pet Door back
5
8
against door jamb. Make sure it is flush without any gaps.
6
/ " (2.5 mm)
7
64
1-800-732-2677
2B
2C
3A
Height
Adjuster
Pre-drilled
Holes