Petsafe PPA11-14766 Manual De Instalación página 7

Sliding Glass Pet Door Options for Exposed or Recessed Doorframes
NOTE: There are three methods of attaching the Sliding Glass Pet Door.
With screws
1
With T-brackets using screws
2
With T-brackets using adhesive
3
Install Sliding Glass Pet Door into an Exposed sliding glass door
1
frame using screws
Prior to installation and drilling, consult your sliding glass door manufacturer's
warranty. Unauthorized changes or modifications may void the warranty.
Installing screws into vinyl door frames or door jambs may crack the vinyl.
3B. To install the Sliding Glass Pet Door into an exposed
sliding glass door frame, find the Sliding Glass Pet Door
center at the top and mark on the sliding glass door
frame. Measure 12" from the top down the side of sliding
glass door frame and mark. Measure 1" above the pet
door in the Sliding Glass Pet Door and mark on the
sliding glass door frame. Measure the center of the
Sliding Glass Pet Door at the bottom and mark on the
sliding glass door frame.
3C. Drill / " (3.5 mm)
9
64
clearance holes
through your
sliding glass door
frame ONLY at the
locations you just
marked. DO NOT
DRILL INTO THE
SLIDING GLASS
PET DOOR AT
THIS TIME.
3D. Before drilling into the Sliding Glass Pet Door, it is
important not to drill inside the Sliding Glass Pet Door
rib lines where the glass is located. Only drill into outer
edge section. You may need to slide Sliding Glass Pet
Door over slightly to correct before drilling.
3C
www.petsafe.net
3B
3D
12"
30.48 cm
1"
2.54 cm
7