Threading The Needle Thread (Medium Weight And Light Weight Fabric) - Janome hd9 Manuel De Instrucciones

Threading the Needle Thread (Medium weight and light weight fabric)

* Use only left twist thread.The left twist
hand.
z
Pre-tension dial
The screw should be lower
than the pre-tension dial.
Screw
Correct
Higher than the pre-tension dial.
Wrong
No gap with the pre-tension dial.
v
!0
o
i
!1
b
!2
!3
w
e
r
!0
o
!1
!2
Wrong
!3
c
Holding the thread
with both hands.
u
y
!0
Wrong
(A)
(B)
x
t
z Raise the presser foot lifter. Press the Up/Down
i
needle button twice to raise the needle to its
highest position. Turn the power switch off.
Set a spool of thread on the spool pin.
Pass the thread through the guide on the thread
guide bar q from the behind.
x Pass the thread through the thread guide plate w,
then draw the thread between the pre-tension
disks e under the pre-tension dial r.
* If the thread tends to twist too much, pass the
thread through the holes in the thread guide
* The standard setting of the pre-tension dial is
t
Insert thread
between the
tension disks.
c Holding the thread with both hands, draw the
thread down and around the tension dial t from
right to left.
Pull the thread up to insert it between the tension
disks y and pass it over the tail of the check
spring u. Then pull the thread down over the
loop of the check spring.
v Draw the thread under the thread guide i and
pass the thread through the thread guide o.
Through the eye of the take-up lever !0 .
* When passing the thread through the eye of
the thread take-up lever, make sure that the
thread is not caught on the thread guide.
Pass the thread through the thread guide o
again. Holding the thread with both hands, slip
the thread into the thread guide !1 as shown.
b Draw the thread down to the needle bar thread
guide !2 , and then pass the thread through the
needle eye on the left side of the needle !3 .
24
q