Petsafe Aqua Fountain Cube Manual De Instrucciones página 7

4. Remove the Housing by squeezing the Bowl just
beneath the locking tabs at the back (Fig. 2)
and lift up on the Housing.
5. Turn Housing over and insert the Foam Filter on
the side of the Housing with the water grate
(Fig. 3).
6. Attach the Housing to the Bowl. Push Housing
down firmly until the locking tabs snaps
into place.
7. Rinse the Charcoal Filter thoroughly under cold
water before placing in the Pet Fountain. This will
remove any loose charcoal dust, which is not
harmful to your pet.
8. Insert the Charcoal Filter. The filter will
fit in the slots on the inside of the
Housing. Make sure it is pushed all the
way down and that the black side of
the Charcoal Filter is facing out toward
the Bowl (Fig. 4).
9. Place the Pet Fountain in a desired
location. To protect your floor always use
a protective mat, such as a towel or water
resistant placemat. This will help protect
your floor from splashing or spills caused
by your pet.
10. Fill the Pet Fountain by pouring water
directly into the Bowl and the Housing,
this will prime the Pump. Leave at least
6 mm to 12 mm of space between the
water level and the rim of the Bowl.
1 1. Attach the lid to the Housing, press down
until you hear it snap in place.
12. Before you plug in the Pet Fountain,
make sure the electrical power cord, the
Adaptor and your hands are dry.
13. Connect the In-Line Plug and make
sure no silver is showing, then plug the
Adaptor into a standard electrical wall
outlet (Fig. 5).
14. Add water to the Bowl as needed. Never
let the water level fall below 13 mm from
the base of the Bowl or you might risk
Pump failure. Replacement Pumps are sold separately by contacting the Customer
Care Centre. Visit www.aquapetfountain.com for a telephone listing of the
Customer Care Centre near you.
Fig. 4
Fig. 5
www.aquapetfountain.com
Fig. 2
Fig. 3
Filter Slots
7