Battery Disposal - SportDOG SPORT TRAINER 1275 Guia De Inicio Rapido

BATTERY DISPOSAL

This system operates on two Li-Ion battery packs (420 mAh capacity for the Collar Receiver, 500 mAh capacity for
the Remote Transmitter). Only replace with battery received from calling the Customer Care Centre. For a listing of
the telephone numbers in your area, visit our website at www.sportdog.com.
Separate collection of spent batteries is required in many regions; check the regulations in your area before
discarding spent batteries. Please see below for instructions on how to remove the battery from the product for
separate disposal.
AT END OF PRODUCT LIFE, USE THESE BATTERY REMOVAL INSTRUCTIONS FOR FINAL DISPOSAL (DO NOT OPEN
THE COLLAR RECEIVER OR REMOTE TRANSMITTER UNTIL YOU HAVE RECEIVED THE REPLACEMENT).
• Using a T8 Torx screwdriver, remove the case screws from your Remote Transmitter.
• Using a 3/32 Allen Wrench, remove the case screws from your Collar Receiver.
• Remove the case back or cover.
• Remove the old battery pack.
• When removing the old battery pack, care must be taken when gripping the connector firmly to avoid
damaging the wires. Shorting the battery wires may cause fire or explosion.
• These instructions are not valid for repair or battery replacement. Replacing the battery with a battery
not specifically approved by Radio Systems Corporation may cause fire or explosion. Please call the
Customer Care Centre to avoid invalidating your warranty.
Please see page 3 of the SportTrainer
Safety Information related to the batteries.
SPORTDOG.COM
SD-1275E Operating Guide for Important
®
11