Fit The Collar Receiver - SportDOG SPORT TRAINER 1275 Guia De Inicio Rapido

STEP::05
PROGRAM THE SYSTEM FOR MULTI-DOG OPERATION
SportDOG Add-A-Dog extra Collar Receiver(s) must be purchased to train additional dogs. Every operational
® ™
mode can be used with multiple dogs.
CHANGE THE MODE
Set display to 2 for multi-dog mode (see STEP 03). Select the number of dogs using the Dog Buttons +/-. After 5
seconds, the Remote Transmitter will flash 3 times to confirm your selection.
1. Program the first Collar Receiver.
A. Turn the Collar Receiver off.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off after 4-5
seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin its normal
flashing. If this occurs, start over from A.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold one of the Side Buttons on the Remote Transmitter until the Receiver Indicator Light
flashes 5 times. If the Receiver Indicator Light does not flash 5 times, start over from A.
2. To match additional collars, use the Dog Buttons +/- for Dog 2, etc. and follow the steps listed above.
STEP::06

FIT THE COLLAR RECEIVER

Please see page 3 of the SportTrainer
Safety Information.
Put the Collar Receiver around your dog's neck and adjust to find the proper fit. Fasten the Collar Receiver so the fit
is snug yet loose enough to allow one finger to fit between the strap and the dog's neck. Fit is important because a
loose collar may cause inconsistent performance.
CONGRATULATIONS!
At this point, your SportTrainer
8
SD-1275E Remote Trainer is ready for field use.
®
SPORTDOG.COM
SD-1275E Operating Guide for Important
®