Preparation; Installing The Antenna; Installing/ Removing The Battery Pack - Kenwood TK-2400 Manual Del Usuario

INSTALLING THE ANTENNA

Antenna

INSTALLING/ REMOVING THE BATTERY PACK

◆ Do not short the battery terminals or dispose of the battery by fi re.
◆ Never attempt to remove the casing from the battery pack.
2

PREPARATION

Screw the antenna into the connector on
the top of the transceiver by holding the
antenna at its base and turning it clockwise
until secure.
Note: The antenna is neither a handle, a
key ring retainer, nor a speaker/ microphone
attachment point. Using the antenna in these
ways may damage the antenna and degrade
your transceiver's performance
1 Align the battery pack with the
back of the transceiver, then
press the battery pack and
transceiver fi rmly together until
the release latch on the base of
the transceiver locks.
2 To remove the battery pack, lift
the safety catch on the base of
the transceiver, then press the
release latch underneath the
safety catch.
3 While pressing the release latch,
pull the battery pack away from
the transceiver.