Basic Operations - Kenwood TK-2400 Manual Del Usuario

1 Turn the Power switch/ Volume control
clockwise to switch the transceiver power
ON.
• The LED indicator lights blue for 1 second
when turning the Power ON.
2 Rotate the Channel selector to select your
desired channel.
• When you receive an appropriate signal, you
will hear audio from the speaker. Adjust the
volume as necessary.
3 To make a call, press and hold the PTT
switch, then speak around the microphone
area using your normal speaking voice.
• Hold the microphone approximately 1.5 inches
(3 to 4 cm) from your lips.
4 Release the PTT switch to receive.
Note: When the battery pack voltage becomes too
low, the Low Battery Warning sounds an alert tone
every 30 seconds and the LED indicator blinks red.
LED Indicator Status
Indicator Color
Lights red
Lights green
Blinks red
Blinks green
Blinks red/orange
8

BASIC OPERATIONS

Transmitting
Receiving a call
Battery power is low while transmitting
Scanning
The selected channel has not been
programmed and cannot be used.
Meaning