Publicidad
Idiomas disponibles
Idiomas disponibles
Using the LED light
To turn on the light, press the
Variable Speed Switch (10) and
make sure the Forward/Reverse
Rotation Switch (4) is on right or
left position. When you release the
Variable Speed Switch (10), the
light will go off after a moment.
The LED Light is also a battery
capacity indicator. It will flash
when power gets low.
The tool and battery pack are
equipped with a protection
system. When the LED Light is
quickly flashing, the system will
automatically cut power to the
tool to extend battery life. The tool
will automatically stop during
operation if the tool and/or battery
pack are placed under one of the
following conditions:
• Overloaded: The tool is
operated in a manner that causes
it to draw an abnormally high
current. In this situation, release
the Variable Speed Switch on
the tool and stop the application
that caused the tool to become
overloaded. Then pull the Variable
Speed Switch again to restart.
• Overheated: Under the
12
condition above, if the tool does
not start, the tool and Battery Pack
are overheated. Let the tool and
Battery Pack cool before pulling
the Variable Speed Switch again.
• Low battery voltage: The
remaining Battery capacity is too low
and the tool will not operate. Remove
and recharge the Battery Pack.
TROUBLESHOOTING
1. WHY DOES THE DRILL NOT TURN ON WHEN
YOU PRESS THE SWITCH?
The Forward/Reverse Rotation Switch, which is on
top of the trigger, is positioned in the lock function.
Unlock the Forward/Reverse Rotation Switch by
putting it into the required rotation position. Push the
trigger and the drill will start to rotate.
2. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, and having not used a
Battery Pack for a prolonged time will reduce the
Battery Pack working time. This can be corrected after
several charge and discharge operations by charging
& working with your drill. Heavy working conditions
such as large screws into hard wood will use up
the Battery Pack energy faster than lighter working
conditions. Do not re-charge your Battery Pack below
Lithium-Ion Cordless Drill/Driver
32°F (0°C) and above 113°F (45°C) as this will affect
performance.
3. THE BIT LOCK
ROTATE.
Pull the trigger and have the drill rotate briefly. The
Bit Lock
normal .
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
See Fig. H
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
ENVIRONMENTAL
PROTECTION
or retailer for recycling advice.
SWITCH WILL NOT
TM
Switch ring should release and operate as
TM
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
EN
Publicidad
