Stove Operation; Switching Off - Palazzetti ECOFIRE ADAGIO Manual De Instalación, Uso Y Mantenimiento

9 STOVE OPERATION

9.1 STARTING THE STOVE
To start the stove hold the
Automatic stove ignition: the stove comes with an automatic device that starts the pellet stove without using other
or drying of certain materials used. This phenomenon will gradually disappear.
"S "
EALED SERIES STOVES
9.2 MODIFYING THE PARAMETERS
power supply.

9.3 SWITCHING OFF

To switch the stove off hold the
To start the stove again it's recommended to wait for the stove to cool down completely.
The stove should only be switched off following the procedure described above. Never switch the stove off by
unplugging it from the power supply.
9.4 OPERATION WITH ROOM THERMOSTAT
When the stove is controlled by an external thermostat (or timer thermostat) the installer must have set
The stove switches on again automatically when the temperature falls below the value set on the external
thermostat (circuit closed).
directly from the control panel.
9.5 OPERATION WITH ROOM PROBE ON THE STOVE
The stove can be switched on/off manually or in programmed mode.
The stove modulates output according to the room temperature read by the probe on the stove (that is, the stove
attempts to maintain the desired temperature while minimising fuel consumption).
the delta set (see par.10.3).
The desired room temperature can be set in the temperature menu
48
USE AND MAINTENANCE
button for several seconds.
.
cod. 00 477 2290 - 04/2015 - Palazzetti - PN - Italy