Connecting Water Supply - Sears Kenmore 57082 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

.
.
(Models 57082,57085, 57089 only) Remove 8
screws on freezer and refrigerator door top trim.
Remove door trim.
Remove 8 top
screws
Remove top hinge cover. Models 57082, 57085,
57089, remove top hinge screw by removing hinge
cover screw with a Phillips screwdriver.
I Wtretrt sT a! ! :iiii e
°
5.
Unplug top hinge wire connectors. Do not remove
green ground wire from hinge (Freezer door only).
Remove top hinge screws. Carefully lift and remove
top hinges.
Freezer door only
Top hinge
-Green ground wire
6.
Carefully lift doors off bottom hinge.
7.
Replace doors by performing steps 1-5 in reverse
order.
Connecting
Water Supply
,_
WARNING: To avoid electrical shock which
can cause severe personal injury or death,
disconnect power to refrigerator before connecting
water supply. After connecting water supply, connect
power.
,_
CAUTION: To avoid property damage,
observe the following:
• Confirm water pressure to water valve is between 20
and 100 pounds per square inch.
• Tighten nut by hand to avoid cross threading. Finish
tightening nuts with pliers and wrenches. Do not
overtighten.
• Check for water leaks and correct if necessary
before returning refrigerator to normal location and
24 hours after connecting.

Publicidad

Tabla de contenido
loading

Tabla de contenido