MO-EL GIROSOLE 769 Manual Del Usuario página 10

To carry out a three phase connection, eliminate the wires A
•
and connect the 3 phases, neutral and ground to the poles of
the terminal as respectively marked L3-L2-L1-N-
a cable H07RN-F 5x1 mm
3. The power cord can reach the appliance in two ways:
From the top (mod. 769 and 769S) and through the opening
•
and the rubber cable-carrier (see fig. 4).
From the bottom (mod. 769) in the following way: unscrew the
•
6 screws of the base, pass the power cord through the plastic
base and through the pole until the head of the appliance and
connect the power cord as above. Tight the screw of the base
being careful that the pwer cord is locked into the opening like
in fig. 5
3. ASSEMBLY AND FIXING (MODEL 769)
Assembling
1. Insert the table (E) into the pipe (A). Then assemble the two pipes
(A) and (G) by means of the coupling (C) and the screws (B) and
(F). Finally, bring the table up to the junction of the two pipes and
tighten the knobs (D) (fig. 1).
2. Insert the assembled pipes into the base and tight the screw until
the pipes are fixed into one pole (fig. 2).
3. Insert the head of the appliance at the top of the pole and tight
the 3 screws until the pole is fixed (fig. 3).
Placement
Place the appliance upon a plain and regular surface. The lamps should
be mounted at a minimum of 180 cm above ground level. A minimum
air gap of 40 cm should always be allowed between the top of the
heater and a ceiling or roof (fig. 9). A safety distance of not less than
100 cm should always be left in front of the appliance or too near.
Be sure that the heater is not facing the ceiling or inflammable sub-
stances; ensure that there is no possibility of inflammable material,
combustible material or curtains coming into contact with the heater,
or lie near the heater.
.
2
10
(fig. 8). Use