MO-EL GIROSOLE 769 Manual Del Usuario página 11

The appliance must not be located neither directly below, nor in
front of a socket-outlet. It must be installed so as to prevent that the
switches can be touched from those who are in the shower.
If there is the risk of accidental falling down of the appliance, fix it to
the in a proper way. For example, the base could be fastened to the
ground with dowels by means of the 3 holes in the base (fig. 5).
4. ASSEMBLY AND FIXING (MODEL 769S)
Ensure that the cable to be used is about 1.5 m longer than required
for connection, so as to enable the fixing operations of the Girosole
to be carried out. Because of the size and weight of the equipment
and of the need to work standing on a ladder, it is advisable that fixing
operations be carried out by two persons. When determining the fix-
ing point on the ceiling, ensure that the surface is flat, level and solid,
and that no electric cables or pipes run beneath it.
1. Use the plastic housing of the Girosole (fig. 12) to determine the
position of the 6 holes in the ceiling. Take care to position the
housing in the desired direction, relative to the exit point of the
cable.
2. Make the 6 fixing holes using a no. 10 diameter drill.
3. Temporarily set aside the housing and push the plastic rawlplugs
into the holes.
4. Carry out electrical installation on the terminal panel of the Giro-
sole according to previous instructions (Ch.2). The power cable
of the ceiling mounted model passes "from above" . It must pass
through the cable carrier and also the hole in front of it in the
plastic connector, so as to exit from the upper part of the plastic
connector. The complete process is shown in fig. 11.
5. Insert the cable through the metal tube (fig. 11).
6. Firmly push the metal tube into the plastic connector (fig. 11).
7 . Fix the tube to the connector by screwing the two 3.5 x 6 self-
tapping screws into the two opposing holes (fig. 11).
8. Insert the cable into the fixing unit (as shown previously) and
insert this into the metal tube. Ensure that the screw on the unit
is aligned with the tube. Press until a click is heard (fig. 12).
9. Use the Allen screw on the unit to fix it to the tube (fig. 12).
11