Finishing The Installation - Sun Ultra 10 Guía De Puesta En Marcha Con Software Preinstalado

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 167
7. At the two nearest corners of the card, push the card straight into the connector
until the card is fully seated.
8. Using a No. 2 Phillips screwdriver, replace the screw securing the card bracket tab
to the system unit chassis.
9. Continue with "Finishing the Installation" on page en-35.

Finishing the Installation

1. Reconnect the system power cord.
2. Remove the antistatic wrist strap from the chassis.
3. Replace the cover.
4. Reconnect the monitor cable and any other peripheral cables to the system.
5. To power on the system, see "Powering On the System" on page en-4.
en-35

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido