Electrical Installation - Franklin Electric MH Serie Manual Del Usuario

Installation Records
To keep an accurate record of your installation, be sure to fill out the data below:
Date of Installation: _____________________________
Model No: ____________________________________
Depth of water (ft): _____________________________
Suction pipe size: ______________________________
Pressure switch setting
ON (psi): __________ OFF (psi): ___________
Suction pipe length (ft.): _________________________
Discharge pipe length (ft.): _______________________
Voltage to motor: ______________________________
Discharge pipe size: ____________________________
Incoming Pressure (psi): _________________________

Electrical Installation

s
WARNING WARNING
!
s
CAUTION
!
s
CAUTION
!
s
NOTICE
!
READ AND FOLLOW ALL INSTRUCTIONS!
Pump connection must comply with National Electric Code (NEC) or Canadian Electric Code
(CEC), and all applicable local codes.
All dual voltage units come factory preset for 230 Volts (Figure 3).
Disconnect power at electrical panel before making any electrical connections.
Supply voltage must be +/- 10% of motor nameplate voltage. Low or high voltage can damage the
motor and will void the warranty.
If possible, connect pump to dedicated branch circuit with no other appliances on it.
Ground motor before connecting to power supply.
MH Series Horizontal Multi-stage Pump
Hazardous voltage can shock, burn or cause death.
If you are not sure of proper electrical connections, consult a
licensed electrician.
Improper wiring can result in permanent damage to the motor.
All electrical wiring should meet the local electrical code.
7