Resharpening The Cutting Tool - Makita EM2600U Manual De Empleo Y De Seguridad

Caution during operation:
If the throttle lever is opened fully during a no-load operation, the engine revolutions increase over 10,000 min
higher speed than required, and keep the revolutions at an approximate speed of 6,000 - 8,000 min
CAUTION: Always reduce the engine revolutions when the equipment is not being used for work.
Operating the equipment at high revolutions when not being used for work will shorten the lifespan of the equipment.
Stopping
– Release the throttle lever (3) fully, and when the engine rpm has lowered,
push the I-Stop Switch (on/off)/Start-Stop Switch (1) to "STOP" position to
stop the engine.
– Be aware that the cutting head may not stop immediately, and always allow it
to slow down and stop fully by itself.

Resharpening the cutting tool

CAUTION: The cutting tools listed below must only be resharpened by an
authorized facility. Manual resharpening will result in imbalances of
the cutting tool, which will cause vibrations and damage to the
equipment.
– cutter blade (star blade (4 teeth))
A professional resharpening and balancing service is provided by Authorized
Service Agents.
NOTE: To increase the service life of the cutter blade (star blade) the blade may
be turned over to allow both cutting edges to wear.
15
-1
. Never operate the engine at a
-1
.
EM2600U
EM2600L