Connection To The Mains - Tecfrigo DIVAE Manual Instalación Y Uso

6. CONNECTION TO THE MAINS

1.
Ensure that mains voltage and frequency are the same as those stated on the rating plate
2.
to the appliance. Ensure that the supply socket has the following characteristics:
earthed. b) It fulfils the requirements of the rated current as set out on the rating plate.
the IEC regulations: - magnetothermal differential switch with In = nominal value as stated on the rating
plate; - Differential with Id sensitivity = 30 mA.
4.
room. The connecting cable to the appliance is H05 VVF, designed for internal use.
transport or storage the appliance has been placed by mistake in a horizontal position or has been turned
upside down, leave for at least three hours in the correct position before switching on the power supply.
5.
Connect the plug (do not use three-way adapters and reduction adapters) (see figure 5).
7. CONTROLS
The appliance features adjusting controls, located at the front of the cabinet.
light inside the display cabinet.
defrosting. 4. Display:
to display the temperature in the appliance.
temperature in the appliance.
which can be changed by pressing button
9. Energy conservation:
shelves into motion.
figure 6).
8. CHECKING CORRECT OPERATION BEFORE USE
CHECK THAT: 1.
The plug is connected. . The refrigeration unit switch is switched on (green light on).
3
. The thermometer shows the desired temperature for the goods to be stored. . The internal lights and
5
the rotation are ON. . The door is properly closed. . The appliance is not exposed to direct sunlight or
7.
to high-powered lamps.
designed to work normally, i.e. +30°C, 55% r.h. (climatic class 4).
30 cm) in front of the motor grille to ensure sufficient airflow.
overloading the shelves and with sufficient space for cold air circulation.
9. REPLACING THE INTERNAL LIGHTS
1.
Switch off the appliance. . Undo the screws which hold the top lamp socket in place. . Remove the
4
protective cover. . Replace the fluorescent tube.
reverse order (see figure 7).
10. REPLACING THE DOOR'S MAGNETIC GASKET
1. 2
Open the door. . Take hold of the magnetic gasket and pull it out of the frame.
gasket and press it firmly down all around (see fig. 8).
Operator's guide
3.
Ensure that there is no danger of explosion (AD) in the
2. Refrigeration :
to switch on the refrigeration system.
a) 5 "SET or P"
Press button
6 "UP"
or button
enable / disable the energy conservation function. (see
2
6
The room temperature does not exceed that in which the appliance is
2
5.
Reassemble by following the above instructions in
7
a)
1. Light :
Thermostat:
to adjust the
once to display the temperature set-point,
7 "DOWN" 8. Rotation :
.
4
8.
There is suitable clearance (at least
9.
The cabinet is suitably filled, without
3.
Insert the new
(A)
attached
it is properly
c) It complies with
N.B
. If during
to switch on the
3. Manual
to set the rotating
3
SLO
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK