Absolute Filter Assembly Or Replacement; Tightness Inspection; Disposing Of The Vacuum Cleaner - Nilfisk VHC200 Manual De Instrucciones

VHC200

Absolute filter assembly or replacement

Do not use the absolute filter again after having
removed it from the vacuum cleaner.
1. Figure 8
2. Cap
3. Closing band
4. Filter shaker stop
5. Filter shaker knob
6. Ringnut
7. Disc
8. Absolute filter
9.
Filter plate
Before proceeding with these operations, turn the vacuum
cleaner off and disconnect the pneumatic system.
Assembly
1. Release stop (3) and unscrew filter shaker knob (4),
release closing band (2) and remove cap (1).
2. Insert absolute filter (7) and disc (6) on filter plate (8),
then tighten ringnut (5). Replace cap (1), lock it with
closing band (2) screw on filter shaker knob (4) and lock
with stop (3).
Replacement
1. Proceed as indicated in step 1 of the assembling
procedure.
2. Unscrew ringnut (5), and remove disc (6).
3. Change filter (7) and replace the cap by proceeding in
the reverse order.
To dispose of the filter put it in a sealed plastic bag, close it
hermetically and dispose of it in accordance with the laws in
force.
GB
C385
WARNING!

Tightness inspection

Hoses check
Make sure the connecting hoses (Fig. 9) are in a good
condition and correctly fixed.
If the hoses are damaged, broken or badly connected to the
unions, they must be replaced.
When sticky materials are treated, check for possible clogging
along the hose, in the inlet and on the baffle plate inside the
filtering chamber.
Scrape inlet (2, Fig. 9) from the outside and remove the
deposited waste as indicated in the figure.
Filtering chamber tightness check
If gasket (1, Fig. 10) between container (4) and filter chamber
(3) fails to guarantee a good seal:
■ Loosen the four screws (2) that lock the filtering chamber
(3) against the vacuum cleaner structure.
■ Allow the filtering chamber (3) to lower down and tighten
the screws (2) once it has reached the tightness position.
If an optimal seal cannot be obtained and the gasket is torn or
cracked, etc. it must be replaced.

Disposing of the vacuum cleaner

Dispose of the vacuum cleaner in compliance with the laws in
force.
To prevent damage to the environment or health caused by
improper waste disposal, please separate this product from
other waste and recycle it responsibly in order to support the
sustainable reutilisation of material resources.
This product can not be disposed of together with other
commercial waste.
10
Figure 11
01/2015