Rotary SPO12 Standard 500 Instrucciones De Uso E Instalación página 13

Latch Cable Guide
Latch Cable
Notice the clearance
removed between
Fig. 12
Control Plate Slot
and Latch Dog Pin.
Latch Cable Sheave
5/16-18NC x 3/8" lg. PHMS
Right Column
Cable Clamp
(2) 3/8" Retaining
Rings
Fig. 14
Latch handle MUST be
positioned at the top of
the latch control cover.
Ball Handle
K) Insert cable in cable clamp along one side, loop
around shoulder screw and back down, inserting
cable along other side of cable clamp, Fig. 13. Place
top back on clamp, barely tightening.
L) Next, pull the control plate down, Fig. 12 & Fig. 13, to
eliminate any clearance between the control plate slot
and the latch dog pin, Fig. 12.
M) Using Pliers, pull cable tight and secure the clamp
close to the shoulder screw. Tighten clamp.
Shoulder Bolt
Feed cable up through Cable
Clamp, loop over end of
shoulder bolt and feed back
down through Cable Clamp.
13
Fig. 13