VITO PRO-POWER Manual De Instrucciones página 27

EN
connect the washer
motor (Photo 18-23):
Place the fuel lever to the ON posi-
tion (photo 18-18.1).
Place the handle in the ON position
air (19-19.1)
Place the ON / OFF switch in the
ON position (photo 20-20.1).
Hold the motor with one hand on
the table. With the other hand
grasp the handle and pull the
starter slowly until you feel some
resistance indicating that is the right
starting point.
When you feel this resistance pull
the rope tight (photo 21).
Repeat until the engine starts.
When the engine starts and is
running correctly place the choke
lever in the OFF position (photo
22-22.1).
When the engine is running speed
can be adjusted by moving the
speed control lever (photo 23-23.1)
for maximum (indicated by a rab-
bit), average speed or minimum
(indicated by a turtle).
turn oFF the engine
(Photo 24 and 25)
To stop the engine, set the ON /
OFF switch to OFF.
(Photo 24-24.1).
warning: Turn off the water
supply and release any accumulated
pressure loading on the trigger until
no more water skirt, put in the posi-
tion of the trigger safety to prevent
unintentional operations.
27