Brandt BFL682ZNW Guía De Instalación Y Uso página 32

①Special flange
self-tapping screws
② Earth wire
③Upper hinge part
Note: Please hold the door by hand
during step 4 to prevent the door from
dropping.
5. Remove the door and place it on a
smooth surface with its panel upwards.
Lever part① and part④ , then loose
screws② , as shown in
Change handle③ to the right side, then
install screws② , part① and part④ in
turn. Loosen screws⑦ , detach part⑥
and part⑤ , turn part ⑥ over and then
install part⑤ and part⑥ to the left side
with screws⑦ .
1 ① Handle covers
② Special self-tapping screws
③ Handle
④ Screw hole covers
⑤ Door holder
⑥ Stop block
⑦ Self-tapping screws
2 3
1 2
6. Place refrigerator flatwise, remove
part③ and then loose screws④ .
Remove part ② and part① .
① Lower hinge part（right）
② Front foot fixed board
③ Adjustable bottom feet part
④ Self-tapping screws
7. Unscrew the lower hinge, change it
to the near hole site, and then screw
up and mount the washer.
8. Repeat step 6, change part① to
left and part② to right and then fix
them with screws④ .
the picture.
part③ .
Lower hinge part (left)
4
3
11
washer
Note: washer may
stick to door.
Finally install