Cleaning And Maintenance; Cleaning And Care - Brandt BFL682ZNW Guía De Instalación Y Uso

4. CLEANING AND MAINTENANCE

Cleaning and care

For hygienic reasons,
(including exterior
accessories) should be cleaned regularly
at least every two months
Caution! The appliance must not be
connected to the mains during cleaning.
Danger of electrical
cleaning switch the appliance off and
remove the plug from the mains socket.
Exterior cleaning
Clean your appliance regularly to maintain
its good appearance.
-Wipe the digital panel and display panel
with a clean, soft cloth.
-Spray water onto the cleaning cloth
instead of spraying directly on the surface
of the appliance. This helps ensure an
even distribution of moisture to the
surface.
-Clean the doors, handles and cabinet
surfaces with a mild detergent and then
wiped dry with a soft cloth.
Caution!
-Don't use sharp objects as they are likely
to scratch the surface.
-Don't use Thinner,
Clorox, ethereal oil, abrasive cleansers or
organic solvent such as Benzene for
cleaning. They may damage the surface
of the appliance and may cause fire.
Interior cleaning
You should clean the appliance interior
regularly. It will be easier to clean when
food stocks are low.
-Wipe the inside of the fridge freezer with
a weak solution of sodium bicarbonate,
and then rinse with warm water using a
wrung-out sponge or cloth.
-Wipe completely dry before replacing the
shelves and baskets. Thoroughly
the appliance
dry all surfaces and removable parts.
and interior
Although this appliance automatically
defrosts, a layer of frost may occur on
the refrigerator's interior walls if the
door is opened frequently or kept open
too long. If the frost is too thick, choose
shock! Before
a time when of food stocks are low and
proceed as follows:
-Remove existing food and accessories
baskets, unplug the appliance from the
mains power and leave the doors open.
Ventilate
accelerate the thawing process.
Caution! Don't use sharp objects to
remove frost from the refrigerator. Only
after the interior is completely dry
should the appliance be switched back
on and plugged back into the mains
socket.
Door seal cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause seals
to stick to the cabinet and tear when
you open the door. Wash the seal with
a mild detergent and
Rinse and dry it thoroughly after
Car detergent,
cleaning.
Caution! Only after the door seals are
completely dry should the appliance be
powered on.
Replacing the LED light
Warning: The LED light must not be
replaced by the user! If the LED light is
damaged,
helpline for assistance. To replace the
LED light, the below steps can be
followed:
1. Unplug your appliance.
2.
and out.
3.
and pull it with the other hand while
pressing the connector latch.
4.
correctly in place.
19
the room thoroughly
warm water.
contact the
Remove light cover by pushing up
Hold the LED cover with one hand
Replace LED light and snap
to
customer
it