Caution!
Fill up the water tank with up to 30L
●
(suggested amount). There is a risk of
over-following if more is added, eve if
the cap cover is dosed.
Before you fill the drinking water into
●
the water tank, ensure that the water
tank is steady and in a correct position.
Other
beverages
●
carbonated
beverage
suggested to be used than
water. Especially beverages including
grain as they can damage the appliance.
Hot water can not be filled into the
●
water tank directly.
Warning!
Don't touch other parts of the appliance
when filling water, it may cause the
water leakage.
Receiving Water
You should use the correct cups to
receive water underneath the water
dispenser.
Dispenser lever
Suggested position
Before you dispense the water, make
sure the lock device is on the "UNLOCK"
position.
unlock
Warning!
The lock is defined as "child lock".
When the dispenser is on "lock", do not
push on the lever too strongly as it
might damage the mechanism.
Cleaning
Carefully remove the water tank out of
the door. Lightly wash the tank, cap
cover, cover bucket with water.
1. After you have successfully cleaned
the appliance, let it dry naturally or by
using the dryer.
2. To avoid the receiving tank from
(milk,
juice,
over flowing, clean it regularly with a
etc.)
is
not
dry towel.
potable
Crisper and Humidity control
The crisper, mounted on telescopic
●
extension
vegetables and fruits. You can adjust
the humidity inside by
Adjust the humidity level with the
●
humidity control sliding block. Slide it
from left to right to increase or decrease
the air hole size.
A bigger air hole means less humidity.
A smaller air hole means more humidity.
•
We recommend that you
vegetables with more humidity and
fruits with less humidity.
When you remove the crisper, pull it
●
forward, then lift the crisper off the
slides. Remember to first remove all
food from the crisper. Once you have
removed the drawers, ensure the slides
are pushed back fully.
17
slides,
is
for
storing
store
Humidity control sliding block
crisper cover
crisper