Brandt BFL682ZNW Guía De Instalación Y Uso página 33

9. Unscrew the upper hinge axis, turn
the upper hinge over and fix axis on it.
Then place it at side for use.
10. Exchange wires both in the left and
right slots of refrigerator body.
11. Move the door
position, adjust part① and the door,
Move the connecting wire② in the slot
of the door from right to left, and then
fix part① and wire② with screws③ .
(Please hold the door by hand when
installing)
12. Connect electrical
accordance with step 3 and then install
part② (which is in the plastic bag).
①
②upper hinge cover(left)
13. Reverse part① by 180°and install it
onto the right corner of the door， then
mount part② . (both of which are taken
down in step 2)
1
14. Take the reed switch out of the
coping block (part③ in step 3) and
mount it on another block for use
(marked "R" in the plastic bag). Place
the removed coping block back into the
plastic bag.
to appropriate
Note： Be sure character side of reed
switch fits well with coping block.
15. Install part① , connect the wire
③
connector② , and then install part③
①
1
②
16. Open the door, mount door racks
and then close it.
connector① in
12
2
3
2