Powervar 420VA Guía Del Utilizador página 10

®
POWERVAR - SECURITY ONE UNINTERRUPTIBLE POWER MANAGER
Start Manager™
Start Manager is special circuitry that enables the internal batteries and allows you to start the Security One
UPM from either the main AC supply or from its own internal battery. On occasion, AC power may not be
available – such as when installing a system in a location where the electrical wiring has not been
completed. Start Manager allows you to start the UPM and its connected system to perform final tests on
both the UPM and the computer systems it's powering.
Communications Manager™
Many uninterruptible power systems provide only a basic software interface with the computer system they
protect. Communications Manager combines the signaling capabilities of the Security One rear panel
communication port with the management capabilities of POWERVAR's communication
software suite. Using your computer's monitor, Communications Manager conveniently displays input and
output voltage, output current, power line frequency, battery voltage, load percentage, and temperature.
Communications Manager even initiates user defined automatic system shutdowns during extended power
outages. Communications Manager allows a system operator to locally or remotely control the shutdown
and startup of equipment connected to the Security One and provides this control either directly or through
the operation of a customized schedule that can be developed to meet specific operating requirements.
Configuration Manager™
Configuration Manager allows the user to control certain parameters of the Security One such as operating
voltage. With Configuration Manager, for example, operating voltage of North American units can be set for
120 volts in the United States or 100 volts for Japanese installations. Some of Configuration Manager's
features are accessed through Communications Manager – such as those that allow adjustment to the
voltage transfer points of the UPM inverter. With Configuration Manager you can even program Security
One output receptacles to turn off themselves and their connected loads at pre-determined times following a
power outage.
User Replaceable Battery
Eventually every UPM requires a new battery. POWERVAR expects the battery in your Security One UPM
to last a minimum of two years – perhaps longer if power outages are short and infrequent. Security One
makes battery replacement by the user easy and fast. And it's not necessary to turn off the UPM or the
connected system. Security One allows the battery to be "hot-swapped" while the system is running.
8