Service Drive Switch (Optional) - Wittur Eco BUS Manual De Instrucciones

19. SERVICE DRIVE SWITCH (OPTIONAL)

20. WITTUR PROGRAMMING TOOL INTERFACE SOFTWARE DESCRIPTION
Valid for software revision starting from „WHD ECO Vx.x, dd.mm.jjjj"
20.1 INTRODUCTION
The ECO-electronic is equipped with a serial communication interface RS 485 to watch/modify data
stored in the electronic. Some data (for example the speed values) are stored in a memory which is
independent from power supply, this memory is called EEPROM. For use of the Wittur programming
Tool see Operating instructions D276Mxx.Wrong adjustments may damage the door mechanic.
20.2 CONNECTING THE WITTUR PROGRAMMING TOOL TO THE ECO-ELECTRONIC
The Programming Tool can be connected directly to the ECO platine at the plug X8, there are no further
adjustments neccessary. Switch off the WPT before connecting to door drive.
20.3 MENU STRUCTURE OF PROGRAMMING TOOL
F1 Door Movement
F2 Coupler Movement
F3 Reopen Time
F4 Next
F1 Reset to Default
F2
F3
F4
F1 Open Speed
F2 Close Speed
F3 Nudging Speed
F4 Next
F1 Brake Parameter
F2 Position Out
F3
F4
F1 Coupler Speed
F2 Coupler Width
F3
F4
Sujeto a cambios sin previo aviso
- RUN position: accepts commands from operation panel,
- TEST position: accepts commands from service keys (X50).
N.B.: The SERVICE DRIVE SWITCH can be adjusted with a screwdriver; rotate clock-
wise/anticlockwise.
The DIP-SWITCH S1/1 must be strictly set in the OFF position.
10.4.2
LOG ON
F8 Back
** WHD-ECO Drive **
Vx.x, dd.mm.jjj
10.4.2
FPC#xxx
F8 Back
** MAIN MENU
10.4.3
F2 Profile Data
F3 Statistic
F4 Next
F8 Back
F1
10.4.4
F2
F3
F4
F8 Back
LOG OUT
10.4.5
F8 Back
EXCELLENCE IN COMPONENTS
10.4.1
10.4.1
F8 Back
10.4.1
10.4.8
Error List
Belt Position
Log Out
F8 Back
3411.32.0100 ed.0
Pag.31.78
F1 Counter
F2 Timer
F3 Distance
F4 Next F8 Back
10.4.6
F1 Energy
F2
F3
F4 F8 Back
10.4.7
Subject to change without notice!
GB