Wittur Eco BUS Manual De Instrucciones página 37

20.4.4 'F4': Next (Door Movement)
F1 Brake Parameter
F2 Position Out
F3
F4
This menu allows you to watch/modify values described in the following chapters by pressing the correspon-
ding function key.
See chapter 20.4.2.1 how to enter values.
This value is stored in the EEPROM.
20.4.4.1 'Brake Parameter'
Because of the adjustment of this parameter the delay and creep to the open / close end is influenced (pre-
adjusted at '5'). The possible adjustment is '0' . . ' 9', but the earliest brake is reached with parameter '0' and the
latest delay is reached with parameter '9' .
20.4.4.2 'Position Out' Relay output
By entering this parameter the Position relay can be adjusted to switch at any door position. Standard
adjustment is 0 (deactivated).
20.4.5 'F2': Coupler Movement
F1 Coupler Speed
F2 Coupler Width
F3
F4
This menu allows you to watch/modify values described in the following chapters by pressing the corre-
sponding function key.
How to enter values see in chapter 20.4.2.1
This value is stored in the EEPROM.
20.4.5.1 'F1 Coupler Speed'
Adjustment of the maximum speed in the coupler area. It is the same for open and close.
20.4.5.2 'F2 Coupler Width'
The parameter coupler width shows the distance which the belt is moving in close end without moving the
door panels.
If this value is changed the door is stopped until the learn button is pressed!
Sujeto a cambios sin previo aviso
F8 Back
F8 Back
EXCELLENCE IN COMPONENTS
3411.32.0100 ed.0
GB
Pag.35.78
Subject to change without notice!