Mount Disc Rotors | Disc Brake Model; Mount Wheels In Frame And Fork | Rim Brake Model - riesel Design b170 Manual Del Usuario

Mount disc rotors | disc brake model

The hubs on the "b170 disc" wheelset have a brake disc mount as per IS2000 standard with 6-hole fixture Disk
rotors with 140 mm or 160 mm diameter can be mounted Disc brakes with center lock mounting cannot be
mounted
1 Mount disc rotors with 6-hole fixture according to the manufacturer's specifications
– 30 –

Mount wheels in frame and fork | rim brake model

Incorrect handling of the quick release skewer may result in failure of the wheels and
WARNING
cause serious, even fatal injuries
Matching quick release skewers are enclosed with the "b170" wheels for rim brakes Check the right and tight fit
of the wheels and quick release skewer in the frame and fork before every ride
1 Position wheel in the dropout Pay attention to proper fit (see fig "dropouts")
2 Insert quick release skewer through the hub The lever is located on the non-drive side in the "OPEN" position
(see fig "lever OPEN/CLOSE")
3 Screw on the opposite nut by hand
4 Turn the lever to the "CLOSE" position In order to generate the necessary clamping force, the lever may only
moved by hand If the lever can be moved very easily, bring the lever back to "OPEN" position and tighten the
nut a little more Next, move the lever again to the "CLOSE" position
5 In the "CLOSE" position, move the lever close to the fork rod or frame tube to the left or right The lever must
not protrude (see figure "lever position closed")
dropouts
– 31 –