Dc Voltage Measurement - Amprobe ACDC-400 Manual De Instrucciones

4.3.2. DC Voltage measurement

Maximum input for DC Voltage measurements is 600V.
Do not attempt to take any voltage measurement that exceeds the limits.
Exceeding the limits could cause electrical shock and damage the clamp
meter.
V
1. Select the ""
2. Insert the test leads into the jack, the red lead into V/Ω jack, and the black lead into the
COM jack. Refer to Fig. 5.
3. Connect the test leads to the circuit, the voltage measured will be displayed with
automatic detection of the appropriate range.
4. If the reading is preceded by the "-" sign check this indicate that Voltage polarity is
reversed. Invert terminal leads for correct indication.
5. Press R-H key you can select manually the measurement ranges in cyclic order. Press
R-H key 2 seconds to return to the AUTOMATIC range selection.
O.L
6. The " " symbol means that the measured quantity is higher than the selected
range. Press R-H key to select a higher range.
7. If reading the display is difficult, press D-H key to hold the obtained value. To exit from
this function press D-H key again.
Fig. 5: Use of clamp for DC voltage measures
"position of selector functions.
WARNING
EN - 11
ACDC-400