Remote Control - Dimplex BLF74 Manual Del Propietário

Operation
control buttons.
In " OFF " mode, power to all
functions is cut off.
When in " REMOTE " mode, the
fireplace's levels of operation are
controlled by the ON and OFF
buttons on the remote control.
C. Manual Control Buttons
The Manual Control Buttons oper-
ate the fireplace levels. The level
is increased every time the "I" but-
ton is pressed the unit will cycle
the levels through sequentially
(from off): flames only; to flames
and heat.
!
NOTE: There is a third level
that does not change the output,
before cycling back to flame only.
The fireplace can be turned off
at any point by pressing the " O "
button.
!
NOTE: The heater may emit
a slight, harmless odor when first
used. This odor is a normal condi-
tion caused by initial heating of
internal heater parts and will not
occur again.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the
16
fireplace off and it will not come
back on without being reset. It
can be reset by switching the On/
Off Switch to Off and waiting five
minutes before switching the unit
back on.
CAUTION: If you need to
continuously reset the heater,
disconnect power and call
Dimplex customer service at
1-888-DIMPLEX
(1-888-346-7539).

Remote Control

The fireplace is supplied with a
radio frequency remote control.
This remote control has a range
of approximately 50 ft. (15.25 m), it
does not have to be pointed at the
fireplace and can pass through
most obstacles (including walls).
It is supplied with one of hundreds
of independent frequencies to
prevent interference with other
units.
!
NOTE: Before attempting any
operation with the remote, pull
the plastic insulator strip out
from between the remote cas-
ing and battery cover (Figure
13).
Remote Control Usage
The remote control operates the
www.dimplex.com