GB
1. D
ESCRIPTION
The DDI78 (Passive Infrared And Microwave Intruder Detector) is an
outdoor Dual Technology Sensor designed to provide volumetric protec-
tion. The sensor uses the unique combination of Stereo Doppler
Microwave and Passive Infrared (PIR) technologies.
DDI78 is configured for "And Gate" operation; i.e. both technology
portions must activate simultaneously for the sensor to alarm.
For optimum performance it is best to use the DDI78 as a motion sensor
to protect specific assets and strategic areas. Generally the sensor is
not used along a perimeter fence area.
2. I
NSTALLING THE
1. Install the mounting bracket.
Review the Installation Guidelines (pages 3-5) for the best mounting
location.
2. Remove the electronic assembly from the housing by loosening the
four screws on the sensor's faceplate and install the sensor
housing/shroud assembly on the bracket.
3. Route the cable through the 1/2" (12 mm) conduit connector into
sensor housing.
4. Remove the terminal block from the main printed circuit board and
wire according to the wiring diagram below.
5. Select the correct lens and height:
Lens
Module
Lens A
Lens B
Lens C
3. W
IRING THE
1. Housing GND (see Note)
2. -ve 12 VDC
3. +ve 12 VDC
Check the LED On/Off switch to verify that it is in the "ON" position. The
LED On/Off switch controls the "Walk Test" LED's and the Voltage OK
LED.
Note: For best shielding from Radio Frequency Interference (RFI) and
transients due to lightning or electrostatic discharge, Aritech highly
recommends the use of shielded cable. When shielded cable is used,
the cable shield (and/or drain wire) should be connected to Terminal 1
(Housing GND) at each sensor. Terminal 1 is connected by a spring
S
ENSOR
Lens
Description
Wide Angle - Standard
Medium Angle - Standard
Long Narrow - Standard
R
EMOVABLE
9
8
7
T
ERMINAL
6
5
4
3
4 & 5. NC Alarm Contact
6 & 7. NO Alarm Contact
8 & 9. Tamper
- 6 -
Mounting
Height (m)
2.4 - 4.5
2.4 - 3.6
2.1 - 2.7
S
TRIP
2
1