Remington iLIGHT Pro Guía De Uso Y Cuidado página 13

Using the Remington iLIGHT Hair Removal System for Treatment
® ®
2c. Place the body part to be treated
over the SKIN TONE SENSOR
(touching the unit) the sensor will
immediately read the skin type.
2d. If your skin tone is NOT suitable for
use, the SKIN TONE SENSOR turns
solid YELLOW and the device will
"BUZZ" once for 5 seconds. After 5
seconds, you may re-try the SKIN
TONE SENSOR (step 2c).
2e. If your skin tone is suitable for
use, a high-pitched "BEEP"
will sound and the SKIN TONE
SENSOR will turn green and the
device is ready for use.
2f. Once the device is enabled, the
ENERGY LEVEL LIGHT and BULB LIFE
LIGHT will turn on and the internal
fan will start. Your Remington iLIGHT
device is set to the lowest energy level
setting and ready for use!
24
Notes:
• Some areas of skin are darker than
others. You must use the SKIN TONE
SENSOR on each different area you
want to treat.
• If you believe your skin is suitable
based on the Skin Tone Chart in
Figure 1, but the SKIN TONE SENSOR
will not enable the device, contact
Customer Service. See page 48.
• If you have tanned skin in the
intended treatment area, DO NOT
use the Remington iLIGHT device in
those areas as your skin may be too
dark for treatment. You should wait
until your tan has completely faded
from any intended treatment area
before using the device.
STEP 3: SELECT ENERGY LEVEL
ENERGY LEVEL SELECTION DISPLAY
illuminates the energy level that the
Remington iLIGHT device will deliver to
your skin, from the lowest level
( ) to the highest level
( ). Higher levels improve hair
removal results, but may be less comfort-
able. To get the best results, you should
use the highest setting that's comfortable.
There are 5 energy level settings on the
device. Whenever the device is turned
on, it is automatically set to the lowest
energy level and the light will be illumi-
nated on the ENERGY LEVEL SELECTION
DISPLAY. See Table 1. To modify the
energy level, press the ENERGY LEVEL
SELECTION BUTTON to increase the
energy level. Once the energy level has
reached level 5, pressing the ENERGY
LEVEL SELECTION BUTTON will return
the device to energy level 1. The num-
ber of lights on the ENERGY LEVEL
SELECTION DISPLAY will coincide with
the change in energy level. See Table 1.
25